![]() I printed this on a Lulzbot Taz6 as it needs the 30cm x 30cm workspace. This vent is printed in three pieces and is held in place on the car by placing neodymium computer hard drive magnets between the layers of the print. The open vent on the MGB gets all sorts of leaves and crud in it, especially on a windy or rainy day. Here are a couple decals that can be print and cut on a Roland in VersaWorks. We purchased a fancy new printer at work and I've been learning Adobe Illustrator. Negative Earth and Unleaded Fuel Stickers Here is a simple replacement for 3D printing. MG kindly blanked out these spaces on the dash with a little plastic rectangle, but sadly one of these has gone missing. There are a couple of optional accessories that my MGB doesn't have. The material is 0.93" thick Acrylic purchased from Home Depot. I designed these lens in TinkerCAD and lasercut it using the Trotec Laser at work. The metal lens cover also twists off by aligning the notches on the backside. It's fairly easy remove the speedo and Tach on these models by rotating it counter-clockwise 90 degrees and pulling it straight out. My Speedo lens on Lucy was extremely discoloured and cracked. You can print (or cut) your own with the models below ![]() I've designed a couple replacement parts for my MGBs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |